OK, I've tuned only a handful or two of the newer gen 5's and something just won't stop bugging me... Knock... Scanner will show spark knock on the histogram, but it's not actually knocking or at least I don't see timing getting pulled from spark advance and it shows absolutely no loss on the dyno in these areas. It will only show 2 to 5 degrees knock retard, but again it makes power with this and isn't actually pulling timing. I've even gone to the trouble of pulling plugs and inspecting due to the confusion with no signs of detonation. Doesn't mean that it actually isn't, but all signs point to the contrary? Then the second thing I've noticed is that it will actually knock (audible) in the lower engine load areas where I obviously go in and pull timing out, but on the knock histogram, shows no knock when it's actually knocking? This is always with untouched knock sensor parameters...
This may have all ready been discussed on here, but was just wondering what others were seeing and what your opinions or corrections for these issues were. Possibly just a scanner issue of mine?
Posting config file just in case... It did originally come from another tuner then I've changed it since then, so I'm not sure.