Just finished putting a Centrifugal system on my Z06. Seems to run pretty good but I can't get rid of the P2229 code.
I tried a break out harness for the baro sensor in the MAF (could this even be the root cause) but it must be wired differently than an LT1. It barely runs and spits out a bunch of codes with the breakout harness.
I've actually seen this question asked before but have not seen an answer.
Anyone?
A&A CORVETTE PERFORMANCE
477 LAMBERT ST
OXNARD CA 93036
WWW.AACorvette.com
A&A CORVETTE SUPERCHARGER SYSTEMS
SUPERIOR ENGINEERING- SUPERIOR POWER
SUPERIOR PRICING- SUPERIOR CUSTOMER SUPPORT
[email protected] 805- 278 4107 Toll Free- 1 888 VETTEPRO
The drop menu and sensor config is different from the LT1 for sure..... trying changing it to NA - MAP - BARO
Yep Andy since it has a centri, gotta set it up like Higgs said (like and lt1 with a centri)
How much boost are ya making? I text ya back btw brother!!
Reply With Quote