someone on another site mentioned that I should do a case learn after swapping a camshaft.....others say only when swapping ecm's
any thoughts on this? will it hurt anything to do so anyhow?
someone on another site mentioned that I should do a case learn after swapping a camshaft.....others say only when swapping ecm's
any thoughts on this? will it hurt anything to do so anyhow?
2003 MY Z06 3.3 liter whipple ...sold at around 1000 rwhp
wip 2015 Silverado w/2.9 Whipple (phase 1 completed) phase 2 in the works
in the scanner, all I found so far is crankshaft learn?? is there more?
2003 MY Z06 3.3 liter whipple ...sold at around 1000 rwhp
wip 2015 Silverado w/2.9 Whipple (phase 1 completed) phase 2 in the works
crankshaft is case learn. make sure you follow the procedure perfectly or it won't work.
is it supposed to give a success message or anything?
2003 MY Z06 3.3 liter whipple ...sold at around 1000 rwhp
wip 2015 Silverado w/2.9 Whipple (phase 1 completed) phase 2 in the works
car runs right?
foot on brake, etc etc? I think it does say complete or something but I haven't done it with the 3.x
It has run well from the get go, even with all the stuff that I changed. Tonite was the first time that I ran open loop, no maf and no stft, and I managed to slowly creep in on a really good vve only tune.
If it were mine, I would probably run it mafless , open loop...it's that close. I set the idle down as low as 450 rpm and it just sits there puring, while jumping between 2 cels ...very nice, so far, especially for someone as clueless as I am with all this.
I have a ways to go yet, but so far so GREAT !!
thanks again
2003 MY Z06 3.3 liter whipple ...sold at around 1000 rwhp
wip 2015 Silverado w/2.9 Whipple (phase 1 completed) phase 2 in the works