2008-2010 Ford Powerstroke 6.4L NOW SUPPORTED

[Eric@HPTuners]

HP Tuners is proud to announce full support for 2008-2010 Ford Powerstroke 6.4L vehicles in the latest beta (2.25.2719 or newer).

Features:
Fastest flashing in the industry. ~9.5 min read (ECM/TCM), ~5 min write (ECM/TCM).
Full editing and scanning support.

[Cody @ ATP]

[rubenk]

Sweeeet, good work guys!

[muz79]

Nice! How do we get the latest beta?

[House]

email support and ask for it with your sn

[midevil1]

This is great...I just bought a 2010 last night. Sure would like to tune the wifes 2013 Escape...

[JDL MOBILE DYNO]

Finally get to play with this 6.4, spartan tuner is good but I been wanting to try a few things good job guys

[midevil1]

Getting check sum error, only partial read. 1 TCM table.? Sent to support.

[braxtonslade]

Is there any possibility of switchable tuning for this platform? It could be a bit of a hassle going back to the tuning shop every time someone needs to change between tunes for economy/performance/towing etc.

[midevil1]

I have 2.25.2721 and I have tried 2 different trucks. An 09 and 10, both give me the Check Sum error for validation at the end of the download.??? WTH?

[muz79]

I have 2.25.2721 and I have tried 2 different trucks. An 09 and 10, both give me the Check Sum error for validation at the end of the download.??? WTH?

I get the same 😢

[Engineer@HPT]

Please email your files to support. These are likely custom tunes.

[midevil1]

Both of these trucks are BONE stock. I emailed to support on Saturday morning...

[midevil1]

In case anybody is wondering, the TCM support is not yet complete. ECM is ready to go.

[Cody @ ATP]

In case anybody is wondering, the TCM support is not yet complete. ECM is ready to go.

Most of the TCM is available. As Eric stated, the pressure tables are about the only things missing at the moment. But shift points, converter lockup rate, etc., are available.

[midevil1]

Most of the TCM is available. As Eric stated, the pressure tables are about the only things missing at the moment. But shift points, converter lockup rate, etc., are available.

Ya, but if I try to read the TCM it will give the Check Sum Error for Validation.

[Eric@HPTuners]

Ya, but if I try to read the TCM it will give the Check Sum Error for Validation.

Use the latest build. If you still get a checksum error, send the hpt file to support and we will get it added.

[midevil1]

Can we et the EGR throttle valve added? Would like to be able to control this for faster warm ups in the winter.

[Eric@HPTuners]

Can we et the EGR throttle valve added? Would like to be able to control this for faster warm ups in the winter.

Please email support

[midevil1]

Eric, Are you still adding parameters to the 6.4 platform? I haven't been able to achieve the scanner screen shot you posted??

Thanks,