2014 Ecodiesel 3.0, no communication with ecm after update

[dieracing]

2014 Jeep ecodiesel 3.0 auto

Connected MPVI2 and followed instructions to perform the initial update. Read the controller but HP only gave me tcm read file. Now I have no comunication with ecm at all and the dash is full of messages from "press clutch to start" to "Service Air suspension" ect.

I hope the ECM is not bricked. Ive put in a support ticket but i wanted to see if I wasteing time and I should begin looking for another ECM.

Im running latest beta software and MPVI firmware is updated.

Any help or advise would be greatly appreciated.

[Bill@HPTuners]

I'm sorry you're having troubles and we'd love to help you. Have you already opened up a support ticket where you've reported the issue? If not, please open a support ticket here: https://support.hptuners.com

[dieracing]

Yes I submitted a support ticket earlier today. It?s number [#408294]