Sequential M6 in FG F6, flat foot shift?

[EFI_tim]

Hi Guys,
I'm only new to the world of HP tuners but I've already got a dilemma. I'm looking at fitting a sequential dog engagement six speed to my BF F6 and was wondering if anyone has tried to have an output from a shifter mounted load cell into the PCM to cut throttle or timing to allow flat foot shifting? Is there a pin that isn't used on the PCM that I could use and more importantly a table in HP tuners that I could setup for this purpose?

Thanks in advance, Tim.

[IH8TOADS]

You could just use a load cell on the shifter and a WOT BOX. I have the same wired to my top clutch switch and I just dab the clutch for wot clutchless shifts.