ver 3.0 vcm enhancements. e40 ecm 2.5bar

[1TLRMS]

i have a e40 ecm with the 2.5 bar enhancement and in ver 3.0 it no longer shows it. already had to relicense the ecm with version 3.0 (dealt with through support) do I need to reapply the 2.5 enhancement also? it does not show up under OS tab in 3.0.

hptuners.jpg

[5_Liter_Eater]

Subscribed

[5_Liter_Eater]

Found this in another thread:

"If you've applied it, it will no longer show up in the OS upgrades... You'll know if your working with a 2bar OS by having the extra VE tables under airflow now, not to mention a few other new tables..."

[1TLRMS]

thanks! I saw the boost VE table but couldn't figure out why it no longer showed under the OS tab as an enhancement. After going through the whole relicenseing issue I was worried that I'd have to redo it also. Didn't want to get into boost without the ECM recognizing it. still trying to figure all this out and haven't got the scanner to read past 105 kpa yet since everything changed. had it all perfect then wham, 3.0 said nope.

[ElecTech]

Go to your calibration info tab, it will show in there