All,
In particular my 2007 Suburban with a 5.3, but several other Gen IV's i've tried the new VVE feature in 3.0 and it doesn't appear to do jack shit for changes?
The VE table i can load, and save the changes i'm wanting to upload, the boxes turn red showing a change has been made but i got to load it in and start the vehicle and its the same shit over and over. I do have the MAF failing at 0hz and 101-103 are set to fail first error, Dynamic set to 7000/6999 but no matter what i do to that VE table the changes do not show up in how it runs.
Am i missing some critical step? Anyone else had this issue?
Like i can whack the low end of the table in idle regions like 80% and its still pig rich with the maf off (cammed) and trims to to pull -25.