Cannot connect to "Vehicle Control & Special Function" part of 3.0 scanner

[Blown_C3]

Good day all,

I am trying to connect to "Vehicle Control & Special Function" part of scanner and the window is blank. see attachment.
However I am able to connect to the car VCM as I can see TPS sensor and coolant and etc.. so VCM is online and taking to the interface.

More details:

- E38 ECU
- Scanner version 3.0.102 ( one of the latest release I guess)

Any ideas?

Thanks in advance

[schpenxel]

Were you connected to the vehicle before you went to that screen?

[Blown_C3]

Thanks for your reply.

Yes I was and I could monitor some of the assuages such as coolant temp, TPS etc..
I am also conected to the car VCM itself but cannot use "Vehicle Control & Special Function" functionality.
This is the log I get when I connect to the car VCM:

Hardware: 0121
Firmware: 0120
PartNumber: 0000006220
BuildDate: 20/09/2012 00:00:00
InterfaceOnTime: 00:28:59.1300000
ROM: 00 3F 00 81 00 01 00 00 FF
Config: CC 88 00 00 00 40
System Info: F7 00 00 01
Comm Errors: 00 00 00 00 00
SPI Info: 40 15 A5 5A 4E 41 00 00
VehicleConnectedTime: 00:28:59.1300000
DetectedProtocols: CAN


SAE J1979 Info: CAN, 500 kb/s, Standard 11 bit, 500 kb/s, ECM: 7E8

ECM: 7E8, CAN
VIN: 1G1YY26Y565100054 - 2006 Chevrolet Corvette, 7.0 L, 8 Cyl
Calibration IDs: 12605732MB, 12602952AJ, 12602946AH, 12605254AE, 12602942AJ, 12605203AL, 12601697KA, 12602934AB
Calibration VNs: 0000E995, 0000C427, 000061E4, 00006C7F, 0000E5A1, 0000D2A8, 000000EC, 00002301
Basic PIDs: 43
Trouble Codes:
Scanning Methods: ISO 15031-5 Mode 0x01 Functional, ISO 15031-5 Mode 0x01 Physical

[SpudzysSpeedShop]

Not to bring an old thread back from the dead but I'm dealing with the same issue now, used the special functions on a truck i just tuned, went to scan a powerstroke to do a cylinder balance test and my functions menu is completely blank. downladed the newest vcm suite same deal, any input would be appreciated!

[15PSI]

Contact support.

[khislop007]

I'm having the same issue.

[Bill@HPTuners]

Not to bring an old thread back from the dead but I'm dealing with the same issue now, used the special functions on a truck i just tuned, went to scan a powerstroke to do a cylinder balance test and my functions menu is completely blank. downladed the newest vcm suite same deal, any input would be appreciated!

Means we do not offer this feature for this application if its blank.