this post might not make the most of sense, so please bare with me.
what areas or tables should i focus on when using a ba/bf/fg pcm to run an ea-au sohc motor instead of a barra?
will basically every area need some attention or is it enough to just work on the sd tables?
is there some information or a thread i could read that would help with this kind of thing?
i've had the pcms running on the sohc before but i basically bandaided the tune by adjusting the stoich value and then messing with the base fuel table, so it doesn't seem like it will take too much work to get it running 100%, just not sure on what is the best way to go about it.