Cammed base tune

[wickedwhite2012]

I have a 216/220 601 lift cut on a 111lsa with Ls 1 1 in take valves with very little intake porting on 799 heads. Can some give me a helping hand and point me in the right direction to get a base tune for the thing. I looking through forum after forum and everyone does everything differently. Just someone point me in the right direction thanks. I'm a noob to all this.

[Frost]

It's easy to get help for specific questions such as "how do I setup the scanner for idle airflow logging" (even though I'm sure it's stickied). When the question requires writing a novel (this is basically "how do I tune?") and can vary wildly based on setup, you often get crickets when waiting.

[waynehartwig]

...Yup, cuz there are lots of books to teach you how to tune...

[wickedwhite2012]

You need a base tune to get it to start and start scanning? If so is there an config file that can be loaded to start with the airflow tuning

[wasyl]

try this
kubutek mod4.hpt

its LS1 with headers, exhaust and cam - 228"/228" .576"/.576" 112LSA
should start, idle and run quite well

best regards

[waynehartwig]

Yes. You should already have a base tune... All cars have them.

[PitchblackC3]

Follow the stickies on setting your idle first and then go from there into VE tuning at low RPMs first.