Am I missing or looking over it or is the MAF table missing ?
I am trying to scale the MAF for a new 5" Intake but can't seem to find the table.
Thanks
Am I missing or looking over it or is the MAF table missing ?
I am trying to scale the MAF for a new 5" Intake but can't seem to find the table.
Thanks
So far I have not played with even looking at what the tunes look like since I don't have access to them. Can you post yours and I'll poke around?
I didn't add the MAF table. The fueling is not based on the MAF readings. Is the truck not running properly?
I can look into adding this if you feel it is necessary.
Eric Brooks
HP Tuners, LLC
Needing the MAF table due to some aftermarket intakes needing additional MAF scaling.
When adding the 5" Intake some of the trucks have an issue with the MAF going out of range and causing a "LIMP" mode feeling. Which causes the truck to run lower boost and also affect the transmissions operation.
Last edited by PureFabrication; 07-20-2016 at 09:02 AM.
Adding the MAF table would most certainly help me out as well.
Please send an email to support and request the parameters added.
Eric Brooks
HP Tuners, LLC
Sent everything in to Support, also sent in the file that was giving me a Checksum Error.
Thanks
Still no response back on the MAF Tables.
MAF tables have been added and will be in tomorrow's release.
Eric Brooks
HP Tuners, LLC
Thanks Eric! Now if only I could get some some help on setting up Monitor pids on the scanner so I can datalog more.