Recently did 2 Hemi VVT cars. Both turned out great, both using the same cam. I am leaving the neural network turned on on both. Both are using a Phaser Limiter.
Both are throwing P000B and P0014 codes. I've disabled the codes for now, but I believe they are showing up because my VVT settings are likely not correct.
I keep seeing references made to changing the VVT settings.....I'm trying my best to get learned up on cam timing as I've been tuning fixed-cam pushrod and OHC motors for the last few years.
With the Dodge VVT system, I see that normally they are set up for 14 degrees of sweep. Limiters hold them to 7 degrees of sweep.
Does this mean that the biggest difference in cam angle between my max advance point where VVT is enabled (900-1000) rpm can only be a max of 7* retarded from that point?