So working on a 2007 magnum xl 6.1 with a vortech. I can not get this thing to rev past 5700rpm. Anyone have any ideas? Running 4th gear on chassis dyno. If i make a sweep in 5th gear it will surpass the mph it is at in 4th gear so i dont believe it is a mph limiter. Help!!
You didn't touch your ENGINE DIAG>GENERAL>Torque Delta and Torque Delta Fault tables, max these out. Also in the same area raise up your Airflow Max by RPM table.
You need to disable baro learn under engine>airflow>general
also your baro voltage low under engine diag> pressure should be .80 and you have it at 2.28
Last edited by GFB Performance; 10-28-2016 at 10:11 PM.
and why do you only accelerate WOT for like 3 seconds during an entire 3.5 minute log? I see one time you in second gear from 2800-4100rpms then letting off. I don't see any acceleration to 5700 rpms.
Get on the highway on ramp, put it in second, and run through 2-3 gear change.
the tune is posted above. on the dyno it makes it to 5700. this datalog is on the street. floor it in second and that is the highest rpm it gets to and goes into limp mode. have to stop the car shut it off, restart it to reset it.