6l80 tutd only shift 1-2 and 3 gear

[Diablo]

Hi, good day to all.

I?m from Chile, and i have been setting a Wrangler Jk whit L99 Engine and 6l80 Transmission, but i have problem whit TUTD, beacause i get it works, but only from 1st gear to 3rd gear, up and down, but i cant get 4-5 and 6 gear.

Tutd is setting Hardwire, and the OS is from a Corvette whit original Hardwire TUTD, on D, all the gears work perfect, ony have problems whit TUTD.

I have attached the file

Please any help, i have read a lot, but i cant find the answer.

Thanx

covertte 2010 6l80 fan 32.hpt

[SultanHassanMasTuning]

speed sensor working?

[Diablo]

speed sensor working?

Yes, work perfect.

I also have set all shift at 512km/h, on TUTD mode.

[Tre-Cool]

the 512kph shift speeds would more likely be your problem.

you need to have them set to low speeds for upshift, otherwise the tcm denies the shift.

do this for your shift speeds for each gear.
1st- all 1
2nd- all 20
3rd- all 30
4th - all 40
5th- all 50
6th- all 50

then have your down shifts set to 5kph below the upshift. Bet it will work as required.

do you mind telling me how your telling the trans to to the tutd shift. Just resistor buttons?

[Diablo]

the 512kph shift speeds would more likely be your problem.

you need to have them set to low speeds for upshift, otherwise the tcm denies the shift.

do this for your shift speeds for each gear.
1st- all 1
2nd- all 20
3rd- all 30
4th - all 40
5th- all 50
6th- all 50

then have your down shifts set to 5kph below the upshift. Bet it will work as required.

do you mind telling me how your telling the trans to to the tutd shift. Just resistor buttons?

At that speed Tutd dont work, but i have set to another speed, and now work properly !

Is working whit 3 resistors to the pin 7.

Thanx a lot.-