I am further refining my tune - 09 Corvette, 6 spd manual, all stock except an A&A Si-trim kit putting out a max of 6 psi.
Most of my tune is completed and I am satisfied, I am now looking into other areas for refinement and adjustments. I am seeking advice, recommendations for the settings to focus on in torque management. My car is a street car, not taken to the dragstrip or track.
I've already changed the following:
Torque Management > General > Torque Limit vs. RPM > all gears set to the max. 6042 lbs. (except 6th and reverse)
Torque Management > General > Torque Limit vs. RPM > Torque Input Max 6042; torque Output Max 6042.
Torque Management > General > Traction Control System > I have Powerhop disabled; and both fuel cutoffs disabled.
These are the only changes I've made so far. Any recommendations on other settings, or am I on the right track with these changes?
Another comment, on a couple of my DL street pulls (rolling second gear) to redline, I am getting tires breaking loose at around 5K to 5500K RPM and serious spikes in spark (Spark drops to as low as -17*, negative 17) and TPS. This is in full traction control mode. Both TCS > spark and ETC controls are enabled. When I switch to full comp mode, these spikes are gone. Should I leave these two enabled?
Thanks!