Hello All,
To try and make this quick, I've spent the past few days digging around online. From what I've seen from some Greg Banish articles, and other posts in the forums, running injectors with known good injector data is critical for an easy tuning process...
The issue I'm having, is I can't seem to find an injector that meets the following 3 requirements:
1) be 63.5 lbs/hr or less at 58 PSI (so that I do not have to scale my calibration), but greater than 47ish lbs/hr
2) Be a LS3 or LS2 sized injector that will fit in my Fast LSXR 102 with LS3 fuel rail
3) Have known good injector data
My estimates look like I should target ~48 lb/hr for 626 crank-ish hp. 416 CI LS3 which is NA only on pump 93 gas.
I've found the forum threads that show what injector information is in the Greg Banish DVD set, and the green tops seem to be the closest to what I need, except that they apparently do not fit in a FAST intake manifold without serious modification.
I'm not opposed to ID, but their smallest injector would require scaling the tune, which I really would like to avoid if it all possible....
Anyone have any ideas on injectors?