Working on 2015 silverado not going into PE. The commanded AFR stays at 14.11. Occasionally PE will engage above 4000 RPMs. Anyone had an issue like this?
Working on 2015 silverado not going into PE. The commanded AFR stays at 14.11. Occasionally PE will engage above 4000 RPMs. Anyone had an issue like this?
Peak torque table needs to reflect actual engine torque.
this is not your normal older e38/e67 pcms
everything is torque based/calculated
Follow @MASTUNING visit www.mastuned.com
Remote Tuning [email protected]
Contact/Whatsapp +966555366161
Put enable torque percentage back up around 30 to 50 or so too - right now unless I'm mistaken you have it setup to delay per other settings in the tune...
2010 Vette Stock Bottom LS3 - LS2 APS Twin Turbo Kit, Trick Flow Heads and Custom Cam - 12psi - 714rwhp and 820rwtq / 100hp Nitrous Shot starting at 3000 rpms - 948rwhp and 1044rwtq still on 93
2011 Vette Cam Only Internal Mod in stock LS3 -- YSI @ 18psi - 811rwhp on 93 / 926rwhp on E60 & 1008rwhp with a 50 shot of nitrous all through a 6L80
~Greg Huggins~
Remote Tuning Available at gh[email protected]
Mobile Tuning Available for North Georgia and WNC