I am working on a RX7 with a 2005 GTO powertrain swap.
The converter is not locking up.
When I log "TCC Mode" it always reads "off" it should go to "apply enb" or "locked"
I have been messing with the wiring for the brake switch inputs to try and get them all to "no"
Attachment 69863
Attachment 69862
But when I apply power to pin 38 brake mod travel switches with brake extended travel.
I can't seem to get both of them to "no"
This is the tune file, although I don't think the issue is calibration related.
Attachment 69861