LC-2 to MPVI Pro - Need Help

[Overkill]

I've searched for an hour and a half before posting so please no lectures!

Can't get my LC-2 to read properly on scanner when connecting to pro.

In scanner, in channel window, I've right clicked, added MPVI Input 1, right clicked, transform, selected LC-2 in both EQ and AFR, always reads at top of the readings, either 1.47 EQ or 22.83 AFR.

Wideband is temp install only, with yellow wire to Pin 1 on Pro, ground in Pin 5, grounds connected together, both power and ground being connected to power port (cig lighter) with adapter.

What am I doing wrong? Or is this just Innovate headaches and I should try a different brand?

[15PSI]

I assume you followed this tutorial?

https://www.hptuners.com/forum/showt...=innovate+lc-2

[Overkill]

Correct, I haven't tried to user define the formula because I don't know what to input, but I've tried the preselectable LC-2 and others but still have this issue. I assume its a wiring issue but I don't know what's gone wrong. Using the yellow wire sends a 0-5v input which I believe is right but the brown wire was no better

[gottogo]

Can you just connect it with USB?

[Philbar715]

Can you just connect it with USB?

Using USB is much easier than messing around with the analog inputs...

[luke]

Have you gone into the logworks programer software and make both the analog out tabs 1 and 2 values the same? I was having a similar issue until I read doing this would help and it did

0.14 volt at lambda 0.5
5 volt at lambda 1.52

try using these numbers in both tabs and see how you go??

I use serial to usb input with the scanner