Results 1 to 2 of 2

Thread: Just installed HPT. Can't read the VCM. Help.

  1. 06-20-2006 #1
    Tommy Tucker
    Tommy Tucker is offline
    Tuner in Training
    Join Date
    Jun 2006
    Location
    UK
    Posts
    34

    Just installed HPT. Can't read the VCM. Help.

    Hi All,
    I'm in the UK so I won't be able to visit this post again for a good few hours. I hope someone can help. I know this problem has come up before but I can't find the answer.
    I have a LS1 GM crate motor and VCM.
    I've just installed my HPT 2.1.10 and am unable to even read the VCM.
    I get the 'verify cable is connected and key is in the run position.' error message. The interface has the power LED illuminated and a slowly flashing 'busy' LED, so that looks ok?
    Is there a way to rectify this?
    I've uninstalled and reinstalled it but no luck.
    This is very urgent.
    Any help appreciated.
    Tom.
    Last edited by Tommy Tucker; 06-20-2006 at 06:58 PM.
    Gardner Douglas T70 Can-Am racer replica.
    346 ci, Stg.2 5.3 heads, hotcam +1.8's, GMPP single plane manifold, Accel TB, custom headers, 42lb SVO's.
    Dry sump, no roof.
    Plenty fast
    Reply With Quote Reply With Quote
  2. 06-20-2006 #2
    EC_Tune
    EC_Tune is offline
    Супер Модератор EC_Tune's Avatar
    Join Date
    Apr 2003
    Location
    Almost 2000 feet.
    Posts
    7,876
    You will have to download a calibration from Horist's site. VCM Suite can't read the GM Crate Motor PCM according to KEN in this post.
    Always Support Our Troops!
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »