Hi All,
This is a second post on the board for this question. I've also put it in the 'help' section. But I need as much info as possible.
I'm in the UK so I won't be able to visit this post again for a good few hours. I hope someone can help. I know this problem has come up before but I can't find the answer.
I have a LS1 GM crate motor and VCM.
I've just installed my HPT 2.1.10 and am unable to even read the VCM.
I get the 'verify cable is connected and key is in the run position.' error message. The interface has the power LED illuminated and a slowly flashing 'busy' LED, so that looks ok?
Is there a way to rectify this?
I've uninstalled and reinstalled it but no luck.
This is very urgent.
Any help appreciated.
Tom.