using cruise control during drivecycle

[Riptide_NVN]

Simple question here. I've done googling and the results are inconclusive.

I have a 2014 GT with a TVS, no cats. Am working on trying to get the O2 and catalyst monitors to pass right now with defoulers on the vehicle.

Is it OK to use the cruise control when trying to run some of these monitor routines or does it invalidate the results? TIA

[Riptide_NVN]

bump*

No definitive answer to this?

[2011Roush]

Forget the defoulers, set tune like picture.

Also, enable rear O2 sensors, FAOSC and heaters. Just make sure rear O2s are plugged in. Then set your DTC codes 420 and 430 to "No Error Reported".

Drive for a couple days so the car can go through it's drive cycles, and make sure you have 15-85% gas in tank, any more or less and the EVAP monitor will not go ready. I just set mine up this way and it passed with flying colors

[Riptide_NVN]

Won't the settings in the photo cause them to show as not available? I've read you can still fail in some states set like that.

Status of "passed" seems ideal.

[2011Roush]

PM sent