I am planning to get PLX wireless AFR gauge and shows on android phone.
I could install wideband sensor instead of upstream-sensor1 , and 0-1V output could connect to E83-E78 but needs to connect heater pins too .
otherwise can gives DTC about heated circuit foult. I ask them if they have information about this issue , they couldnt inform me and ask through this issue by forums.
Do you know if SM-AFR support sensor heater circuit simulator output ?
thx.
not worth the time... and no one simulates a heater circuit with their widebands...
its not any more accurate than the oem unit. just install it separately and use the 0-5v range to tune with the mpvi module.
2000 Ford Mustang - Top Sportsman
thx for reply ,
there are one simulate heater circuits that I found , here is the link.
http://www.ac.com.pl/ru-produkty-aut.../stag-afr/337/
I think should get this and try and see the result.
if you want to test it go ahead but your real limitation is the fact your cramming everything into a 0-1 volt range. the accuracy comes from expanding that range to 5v
2000 Ford Mustang - Top Sportsman
Reply With Quote