Results 1 to 5 of 5

Thread: No option to remove vats

  1. #1
    Tuner
    Join Date
    Feb 2018
    Location
    NC
    Posts
    53

    No option to remove vats

    i dont see an option to remove the vats on 2000 buick lasabre. why isnt it offered? it only gives the option of serial or PWM.
    Attached Images Attached Images

  2. #2
    Senior Tuner
    Join Date
    Feb 2006
    Location
    Canada
    Posts
    1,957
    That's where you disable it, then go into DTCs and set the two corresponding DTCs in there to NO ERROR REPORTED. Post the tune bud and Ill point them out for you. If the cylinder goes bad there is no choice but to replace it. That is a different issue than just "VATS".
    2000 Trans Am WS6

  3. #3
    HP Tuners Support
    (foff667)
    Bill@HPTuners's Avatar
    Join Date
    Jun 2004
    Location
    Hailing from Parts Unknown
    Posts
    28,247
    This is covered in our sticky at the top of this section

    http://www.hptuners.com/forum/showthread.php?t=12399
    It doesn't have to be perfect, it just needs to be done in two weeks...

    A wise man once said "google it"

  4. #4
    Senior Tuner
    Join Date
    Feb 2006
    Location
    Canada
    Posts
    1,957
    I totally forgot it was a sticky Bill! Been a while since doing one of these
    2000 Trans Am WS6

  5. #5
    HP Tuners Support
    (foff667)
    Bill@HPTuners's Avatar
    Join Date
    Jun 2004
    Location
    Hailing from Parts Unknown
    Posts
    28,247
    Yup, originally posted in 2007!
    It doesn't have to be perfect, it just needs to be done in two weeks...

    A wise man once said "google it"