-
Tuner
Benching cm849a
Is it easy enough to bench this ecm with Cummins cables (which I have) or would I need to make up some?
-
Tuner
Nobody?? Ive got pinouts and tried to connect with HP using fly wires between ecm and obd2 plug but am getting a time out on the can bus. It?s internally resistanced at 120ohm. Ive tried a second 120ohm resistor at the obd2 plug to bring the total down to 60ohm, or no resistor at all. No difference
-
Tuner
So perhaps ecm is dead i?m thinking. Will try another one. Thanks for all your help
-
Tuner
You are on the right can bus?
-
Tuner
Pin 4 & 5 of C1 60 way. Can + & Can - respectively
-
Tuner
I think Efi-Connection might sell a bench harness for this ecm. I haven't checked but I know they have a bunch of cummins harness's for their bench setup.
-
Tuner
I did see that. I checked out the picture of theirs and I’m pinning it the same. Every time I get a fail to detect protocol error. I’m thinking it’s dead. Even tried with other software which times out on the can response