I'm looking for the Coyote ECM pinout for a bench harness, I haven't found anything.
I'm looking for the Coyote ECM pinout for a bench harness, I haven't found anything.
http://www.lsxcalibration.com - Lsx Tuning France - Spécialisé Reprogrammation moteur Corvette Camaro Hummer, Ford Mustang et autres véhicules US
Check our Facebook page http://www.facebook.com/lsxcalibration.com
I have it, can post later tonight.
have you found it ?
http://www.lsxcalibration.com - Lsx Tuning France - Spécialisé Reprogrammation moteur Corvette Camaro Hummer, Ford Mustang et autres véhicules US
Check our Facebook page http://www.facebook.com/lsxcalibration.com
Try this.
Last edited by txcharlie; 06-01-2018 at 11:59 AM.
Here are the pinout for a 13/14 body, trans and engine into the ecu.
Hello, does anybody have the same complete pinout for 2019 GEN3 Coyote?
sure, here you go, gen 3 pcm has 3 connectors: engine trans and vehicle. Here's the 3rd one that you need "E".
this is a minimum if you need to bench it:
image.png
v-performance.pl/
facebook.com/veee.performance/
https://www.instagram.com/v.performance.pl/
Remote tuning:
[email protected]
+48 697276579
how about what wires are needed for a gen 1 I am just wanting to run one on a stand with a computer and what i need to start even in limp mode i am just wanting to check motor out