LM-1 Custom PID or LM programer What's better??

[adambrandt]

OK....

I have my LM1 installed and I am using the MPVI pro. I have the LM1 working with the MPVI pro. The data from the MPVI and the LM1 do not match.

My LM1 will show 14.5 at idle and my MPVI shows 13.1. I know that i have to set up the voltage offset.

WHAT is the better(easier) way to do this and how??

I have read posts about creating a custom PID. I have read others that say to adjust with the LM programmer software.

I know that 0v=10
and 5.v =20

I just don't understand the formulas that some of you are posting.

Thanks,

Adam

[dc96819]

Ive just been tru that.See AFR OFF a few post down.Thats a big offset.
Whats the voltage difference.
Make a raw voltage pid.Go in table display right click on one of the
EIO inputs and choose raw voltage.Then put your W/B output in that input
and read the volts
S.E will help you.He must be on lunch right now