OK....
I have my LM1 installed and I am using the MPVI pro. I have the LM1 working with the MPVI pro. The data from the MPVI and the LM1 do not match.
My LM1 will show 14.5 at idle and my MPVI shows 13.1. I know that i have to set up the voltage offset.
WHAT is the better(easier) way to do this and how??
I have read posts about creating a custom PID. I have read others that say to adjust with the LM programmer software.
I know that 0v=10
and 5.v =20
I just don't understand the formulas that some of you are posting.
Thanks,
Adam