i am having trouble with the vats
all i found from a search was to go to -system-general-vats-" none " Is this correct?
i tried that and when i rewrite it goes down the list saying "complete" then gets to VATS and says "failed" i have tried a couple times with the same results.
this is a transplanted motor so i dont have a bcm or anything , the truck will start and die after about a second
any help would be appreciated
'72 International Scout II
'01 5.3L/ TH400/np203/205 doubler/D60 HP ford front /10.5" 14b Rear 38x15.5x15 TSL radials
Sounds like a Ken/Chris Question if my suggestion doesn't work...
Turning VATS off by setting it to None should have fixed the problem. Try re-reading the file from the PCM & see if VATS is truly turned off (None) in the system section. Just a good double check...
Always Support Our Troops!
well after a few more trys it worked
'72 International Scout II
'01 5.3L/ TH400/np203/205 doubler/D60 HP ford front /10.5" 14b Rear 38x15.5x15 TSL radials
Congrats! Now for the tuning fun...
EC
Always Support Our Troops!
Reply With Quote