Results 1 to 8 of 8

Thread: BA xr6 turbo auto to manual

  1. #1
    Tuner in Training
    Join Date
    Oct 2017
    Posts
    14

    BA xr6 turbo auto to manual

    Hi,

    Can any one point me in the right direction to change the settings in our auto ecu to allow our manual gearbox to run?

    Conversion is done and starts etc, just has a limiter at 2500 rpm

    I believe we need to change a few settings for vss?

    Thanks

  2. #2
    Advanced Tuner
    Join Date
    Feb 2015
    Location
    Perth, Australia
    Posts
    974
    post your file

  3. #3

  4. #4
    Advanced Tuner
    Join Date
    Feb 2015
    Location
    Perth, Australia
    Posts
    974
    hyperdrive.hpt

    see below for BA swapped from BTR4spd to glide or effectively a manual

  5. #5
    Advanced Tuner
    Join Date
    Dec 2009
    Location
    Bayside, Melbourne, Victoria
    Posts
    301
    How did you go with this, why didn't you just start with a base manual XR6T file rather than try & mod a auto file?

  6. #6
    Tuner in Training
    Join Date
    Oct 2017
    Posts
    14
    All went well, was not aware you could write a manual tune into an auto pcm.

  7. #7
    Advanced Tuner
    Join Date
    Dec 2009
    Location
    Bayside, Melbourne, Victoria
    Posts
    301
    ahh cool, glad it worked!
    But yeah in future you can check calibration listings & make sure it's the same year/model & write entire(only option with HPT, AFAIK) for the controller & it will write the manual calibration over the existing auto calibration but leave all the other security items needed the same to work!

  8. #8
    Tuner in Training
    Join Date
    Jun 2017
    Posts
    15
    Trans>General

    Automatic=Disable
    Load Switch=2