I'm getting the default value of 40% alcohol. Here is what iv'e done.
Fuel Sys>Diagnostics>FlexFuel>Sensor Diag | Enabled
Engine>Fuel>Flex Fuel>General>Flex Fuel | Enabled
Engine>Fuel>Flex Fuel>General>Flex Sensor | Sensor
Engine Diag>DTCs>P0178> | SES Enable and MIL on Second
Engine Diag>DTCs>P0179> | SES Enable and MIL on Second
I've also checked the signal wire pin is going to pin 38 of the connector multiple times. I took the pin out and put back in. I confirmed the Sensor is getting battery voltage at the plug. Looking at the plug with the "Hump" facing upwards I have power on the left most pin and ground in the middle.
I'm not sure what I'm missing. Any help would be grateful.
Camaro_2018_08_10.hpt