I have followed the directions to set up, but my VVE table axis is set up in RPM and MAP/BARO ratio vs. RPM and MAP. Not sure what to do as I have not found any other tables with this information in it to copy MAP only. Actually using V4, just copied the tutorial title. Capture.PNG
Last edited by DGS; 09-04-2018 at 08:40 PM.
log map and baro channels and then use the maths function for pressure ratio. i know its available as a channel for logging because i used it before specifically for the vve stuf.
2000 Ford Mustang - Top Sportsman
Thank you. I will go that route.
I posted again at this link. Could you provide some assistance? Thank you. I don't know how to refer or link any other way in this forum as I am new to it. If I had an older vehicle (Cobalt SS), the information in your links would be easier to apply. https://forum.hptuners.com/showthrea...s-to-VVE-Table
Last edited by DGS; 10-07-2018 at 12:12 PM.
Reply With Quote