So I am doing an engine swap into a 63 Nova that is using a 2013 PPV L77 (6.0, DOD, AFM) and also running a 6l80e. Want to use a Lokar shifter for the 6l80e that has the detents for the TUTD shifting but requires the resistor setup normally used on C6 Corvettes as the PPV uses a CAN signal from the BCM to read shift requests.
Having never done a setup like this, I have always used a Corvette tune for engine and trans, Im wondering if I need to do a segment swap for the TCM side to do this or if I just need to pin the transmission correctly for the C6 style trans. I am not sure if I just need to wire the trans by adding a circuit to PIN 7 with the correct resistor pack or if I have to program the TCM as a Corvette to get that working properly?