Results 1 to 3 of 3

Thread: Limp / Protect Mode (VCM Scanner) PID switching on/off

  1. #1

    Limp / Protect Mode (VCM Scanner) PID switching on/off

    I've been trying to fix the good old P3032 and U1424 code. It's been raining, so I can't do too much more; However. I have made progress and it doesn't seem to be coming on anymore normal driving (will test more when dries up) but after an hour of driving I didn't see the codes come back. Fingers crossed.

    My issue now though, I have been logging Limp / Protect mode in the scanner. I noticed that it comes ON and then OFF. I don't know what that actually means. It's not setting a code. I don't have an SES. Is this just some kind of Torque management protection coming on for the Trans? I have Trans TC turned on for obvious reasons.

    I have attached the limponoff.hpl file which shows it's mostly off. Then I have another file limpshare.hpl which shows it's mostly on. I can't tell the difference driving around in the rain, seems to run the same.

    So, what really is this PID trying to tell me?

    It's a 2015 Hellcat, auto.
    Attached Files Attached Files

  2. #2
    Figured it out. Issue is a non-issue at all. Car made 931RWHP and 841 RWTQ just now. All codes fixed.

  3. #3
    So what was the fix?