Limp / Protect Mode (VCM Scanner) PID switching on/off
I've been trying to fix the good old P3032 and U1424 code. It's been raining, so I can't do too much more; However. I have made progress and it doesn't seem to be coming on anymore normal driving (will test more when dries up) but after an hour of driving I didn't see the codes come back. Fingers crossed.
My issue now though, I have been logging Limp / Protect mode in the scanner. I noticed that it comes ON and then OFF. I don't know what that actually means. It's not setting a code. I don't have an SES. Is this just some kind of Torque management protection coming on for the Trans? I have Trans TC turned on for obvious reasons.
I have attached the limponoff.hpl file which shows it's mostly off. Then I have another file limpshare.hpl which shows it's mostly on. I can't tell the difference driving around in the rain, seems to run the same.