Ok, so I have my PID setup up for 10-18. I think ive got my offset taken care of. I setup LM programmer to match. Heres what happens:
I warm up the sensor, start logworks and the scanner. Now that the offsets are taken care of, they're both reading the same, but very very lean!!! Like 17.x to 18.2 or 3. It fluxuates between. I pull the sensor, recal for open air, reinstall and all is good. I go for a log session and all is good. I get back and check the data on my laptop, get back to go do another log, warm up the sensor and its off again. what gives??