-
Tuner
Logging 2 widebands at the same time
I have a AEM wideband in each bank and I've got scanner channels setup for MVPI 1 and 2.
However, I'm a little stumped as to whether I can use a histogram like EQ Err for each wideband.
The generic sensor is EQ Ratio, but I'm not sure what MVPI port it is using and it doesn't work when I select EQ Ratio # 1 or # 2.
Any tricks? Or do I basically just log one bank at a time?
Last edited by kenandjenn4551; 09-28-2018 at 10:58 PM.
-
Senior Tuner
u may have to make a maths error that adds them both together and then halves it so u get the overage of both banks for fuel corrections, but also watch both encase something its happening that it wont show u on a averaged workout, or u may just have to get error from one bank