I have made some graphs to monitor my WB and EQ Error. The 2013 Malibu 2.0 LTG Turbo has a VVE table with MAP/BARO ratio and RPM. Now that it appears I have them set up correctly, how do I apply the changes to the VVE Table Editor? Right click Paste Special Multiply by % - Half? I am unsure what the cell value actually is in the VVE Table Editor? Just unsure if I am utilizing the right data (number,percent, Lambda) from the charts. I have logged data and collected what appears to be a sufficient amount of hits. I have viewed numerous links, but none of them cover the VVE Table Editor configured like my vehicle supplies (MAP/BARO RATIO and RPM). The screen snapshots shown are taken from some of my logs. I have extensive logs with much more data collected. This is a stock tune and nothing has been modified. If accurate, there are some fairly lean numbers in some of the cells. I am running 93 octane. I have not noted any Knock Retard values. I have an excessive number of parameters in my table, but I wanted to make sure to log everything so I can chart any parameter I may need. Better to have more than less. That way I can always modify my graphs and charts and re-play the log(s) to analyze the result without having to create another log. At least until I modify the tune and then of course log and analyze further. I am using MPVI2 and AEM OBD2 setup. The Lambda and Error tables appear to add up/balance out when comparing the values in a specific cell, so it looks accurate. Any input would be appreciated.