Hello everyone, I have not done much of any Ford calibration work especially with HPTuners. Friend of mine has a Automatic 2016 Mustang GT, stock cats and H pipe, aftermarket mufflers and asked if we could install Ghost Cam calibration. I was following a very good write up in here from back in 2014 but I still have issues im trying to figure out.
Idle>General>
- Enable RPM Error: set to 200rpm
- Minimum VSS: set to 0mph
Idle>RPM>
- Transmission Based Setpoint P/N: set to 850rpm
- Transmission Based Setpoint Drive: set to 800rpm
Airflow>Varible Camshaft>
- Intake Valve Opening: Map point 0 and 1 set to -40 crank angle
- Exhaust Valve Closing: Map point 0 and 1 set to 20 crank angle
Engine Diag>Misfire>
- RPM Min: Set to 950rpm
Once the car starts it has a high idle then settles after about 2min, during that time it sounds like Ghost Cam is working and it has a great lope, but then settles the rpms and reverts back to normal idle operation. I read their were was to make conditions to enable this, most are temp, and no cel's which we have met. I have also tried changing the transmission based set point higher as well Drive(ect) but still seem to go back to normal idle. Attache dis the file i have been working with:
2016 Mustang GT - WT 0001.hpt
Any more information on what i may have missed is much appreciated.