hello hptuner gurus. I'm needing some assist, and bare with me as ive been turning wrenches for the better part of 20 years but I'm new to the hptuning world. so details on the build, gen 4 6.0l lq4, mild cam, tbss intake, single S480 turbo, with flex fuel and 4l80e trans. I'm in the middle of modding a stock 06 van harness to fit my needs, adding the flex fuel sensor, deleting emissions, rear 02s, etc.....
so heres the question I need verification on if it can or cannot be done and why. I'm looking to delete the MAF because the truck will be tuned in SD. any issues deleting this in the tune as well or any one care to give a brief overview of how to accomplish that so I have a rough guide where to dig? second and harder question is I'm adding wideband and inputting it via the egr pinout of the ecu so I can view it both via hptuner and gauge. the turbo manifold is cast so I cant run the passenger front 02 bung anywhere but the downpipe. if I do that then my front 02s would be comparing driversbank(in the crossover pipe) and the overall in the downpipe. so can I delete the driverside front 02 sensor in hptuners and harness and only run a single pass front 02 in the downpipe for tuning and my wideband right next to it? I just don't want to have unnecessary wiring and three-4 02 sensors in my short downpipe for no reason.
thank you all for any assistance you may be able to provide on this. I wasn't able to find any concrete info on doing things this way so maybe this will help others in the future as well. have a great day! Matt