N2MB WOT box Open Loop Fault on 2 step

[Stangguy]

Got a 15 Mustang V6 here with a N2MB WOT box and on the 2 step and letting off it goes into an open loop fault for about 5-10 seconds. Disabled coil codes as well as misfire detection. Any other ideas?

[Witt]

Fix isn't possible with HPTuners. You need access to SCT Advantage to be able to disable the coil test rpm limit or set the 2 step to a higher rpm than the stock test limit.

[Stangguy]

I pulled up the strategy in SCT and coil test is set at 3200 while the WOT box is programmed at 3800rpm