I have a converted LT1 to LT4 blower set up on a 2014 C7 manual. This calibration, starts and idles. Can the VVE be extended from .880 to 1.24 ? or are most not going that high on their conversions?
I have a converted LT1 to LT4 blower set up on a 2014 C7 manual. This calibration, starts and idles. Can the VVE be extended from .880 to 1.24 ? or are most not going that high on their conversions?
If you hover over the pressure tab it will give you the option of going all the way to 3.0.
I've extended my Pressure Ratio to 1.85 which I see with my LT4 conversion. So 1.24 sounds really low and should match what the engine produces.
You can mod it to whatever you like...
Email Tunes, [email protected]
96 TA Blown/Stroked, 4L80E/Fab 9
15 C7 A8 H/C 2.3 Blower/PI
14 Gen 5 Viper
Custom Mid Engine chassis, AKA GalBen C
I expanded the values and seems to be good.
The only issue I am having right now is code for P0106 map sensor. I chose the SC-MAP-SCIAP-TIAP and getting error code. Do you have suggestions for correcting this or is this something hardcoded in the background for LT4 vs LT1?
Normally for the LT1 to LT4 conversion the Map Sensor Config stays 'NA-TIAP'.Originally Posted by [email protected]
I just got our L86 to LT4 blower swap running and I was wondering the exact same thing. It is running and driving right now. I am using the LT4 map sensor in the rear of the blower with the IAT wired into it. The front LT4 map sensor is not being used. We are running a 6l80E transmission. It idles and revs up great. It leans out very easy so I am taking baby steps with it.
Last edited by vannatta20; 12-19-2018 at 09:45 AM.