When i enable high idle in hptuner program it doesn't seem to work. I have a 04.5 auto. Any tricks to making it work?
When i enable high idle in hptuner program it doesn't seem to work. I have a 04.5 auto. Any tricks to making it work?
2004.5 Cummins.
Borgwarner 13009097047 s300sxe 63-73 compressor 63/80 super core turbine housing 80mm .83 A/R Twin Scroll Housing,
50HP BMS/Exergy Injectors
BD T4 manifold,
BD CAI,
5" turbo back exhaust,
turbosmart ext wastegate,
BD lift pump with 2 mic filter and h2o separator,
banks intercooler, Banks intake horn,
slightly built tranny.......
No issues with my 04.5. I have my increment rate set at 50 rpm, min rpm at 1100 and max at 1500. You have cruise turned on and you press "set" right? Works every time for me, then I can use accel/coast to raise/lower rpm. I always have my park brake set, not sure if that is a requirement but thats what I do.
2004.5, built 48re, Fass lift pump, s364.5 with a s483 compounds, ARP studs, 103# valve springs, 110hp injectors, 669hp 1075ftlbs
I can?t quite remember but I think parking brake had to be set on the automatics. An ecm wire gets grounded through the parking brake switch to enable it in addition to the software enable. With manual transmissions the wire doesn?t exist, an ecm pin has to have a wire installed and ran to ground in order to be able to use the manual high idle in addition to the software enable.
You also can't be holding the brake pedal, or it won't activate.
2004.5 Cummins.
Borgwarner 13009097047 s300sxe 63-73 compressor 63/80 super core turbine housing 80mm .83 A/R Twin Scroll Housing,
50HP BMS/Exergy Injectors
BD T4 manifold,
BD CAI,
5" turbo back exhaust,
turbosmart ext wastegate,
BD lift pump with 2 mic filter and h2o separator,
banks intercooler, Banks intake horn,
slightly built tranny.......