Results 1 to 3 of 3

Thread: Dtc code set when reading truck

  1. #1

    Dtc code set when reading truck

    First time i read the ecm in vcm editor i got a dtc of u0107. I went to the read dtc under the scanner and it cleared. I read it again and the same thing.

    Is this a bug?

    Once i clear its fine and it reads the program fine as well.

    Its a 2005 escalade.

  2. #2
    HP Tuners Support
    (foff667)
    Bill@HPTuners's Avatar
    Join Date
    Jun 2004
    Location
    Hailing from Parts Unknown
    Posts
    28,247
    Not a bug.

    When the other modules on the same bus as the pcm are told to SHUT UP during the read process they tend to throw comms codes such as this. Nothing to worry about and perfectly normal.
    It doesn't have to be perfect, it just needs to be done in two weeks...

    A wise man once said "google it"

  3. #3
    So just clear the dtc when i get done reading and roll on?

    I just wanted to make sure there wasnt anything going on before i try to write back to it.