So I have been trying to mainly learn about how the throttle works in these new things, here is where I am at and looking for more info...
It sounds like consensus is leave the negative numbers alone, so I left the top two rows.
I am trying to fix areas where I am at 40% throttle in a given gear and the actual throttle goes up to 70% or more.
From what I gather, PE does not enable unless pedal position is over a limit. The frustrating thing there is I am not entering PE in high loads where actual throttle goes to 100%.
The other thing I did was changed some cells 10% (lower) in attempts to better line up the real torque I am looking to get for that pedal position. I also blended some areas to make it a little smoother transition.
Good, bad, yes, no? I am hesitant to try without some feedback on what you guys do. I was going to leave tow mode alone so worst case I switch to it (assuming that is true).
Thanks.
Stock table.PNGNew table.PNG