Amid all my tries I cant seem to figure out how to set-up my AEM x-series OBD II.
I was able to set-it up to read the wideband but I'm looking to see if anybody knows how to set it up to read % of fuel correction in the VCM scanner.
Hopefully if it can then I can go into my Virtual vve and multiply by % and adjust manually as needed.
I have the mpvi2 and vcm suite 4
Attached is a VCM layout file and test run file
If you look at the graphs I can get the afr error to move around in the cells but it isn't logging anything.
if u use the maths error and then fit a WB on a different input u then just have to change the input on the maths error to suit and it should work as normal
Bump cause was easy once I realized I had to re-sync my MVPI2 in the VCM scanner program since I upgraded to Pro. Was doing everything right except for that.