Results 1 to 3 of 3

Thread: VCM Set-up for AEM wideband

  1. #1
    Potential Tuner
    Join Date
    Oct 2018
    Posts
    4

    VCM Set-up for AEM wideband

    Amid all my tries I cant seem to figure out how to set-up my AEM x-series OBD II.

    I was able to set-it up to read the wideband but I'm looking to see if anybody knows how to set it up to read % of fuel correction in the VCM scanner.
    Hopefully if it can then I can go into my Virtual vve and multiply by % and adjust manually as needed.

    I have the mpvi2 and vcm suite 4
    Attached is a VCM layout file and test run file

    If you look at the graphs I can get the afr error to move around in the cells but it isn't logging anything.

    Any help would be greatly appreciated.

    Lastly I did try to set it up according to the thread "HOW TO: Setup AFR / Lambda ERROR Graphs vs. VE Table (non Virtual VE Vehicles)"

    It didn't work
    Attached Files Attached Files
    Last edited by joe53016; 4 Weeks Ago at 08:53 PM.

  2. #2
    Senior Tuner
    Join Date
    Jan 2014
    Location
    Australia
    Posts
    1,013
    if u use the maths error and then fit a WB on a different input u then just have to change the input on the maths error to suit and it should work as normal

  3. #3
    Potential Tuner
    Join Date
    Oct 2018
    Posts
    4
    It took some time to figure it out but I got it.

    If anyone wants to know how let me know.