-
Tuner
Still learing...Virt torque table question...
Just saw something posted that made me think about this...
If I edit the virt torque tables, e.g. add 5% in a certain RPM/area, generate coefficients, save it, upload it, close editor....Then later,
I re-open the same tune/editor and want to add another 5% to virt torque in that same area, will I end up with a total of 10% increased coefficients or did I just increase them by only 5% total again?
Someone mentioned that when you open the virt torque tables they are always default values?
I always wondered how these work. When you open the tables, do they reflect values taken from the existing coefficients in the tune?
TIA,
Pj
-
Tuner
I meant to say "Still learning...". Guess I need to learn how to type as well...
-
Tuner