problem copy and pasting data

[saleen9973]

Hey guys i have a 2005 gto with E40 ecu. I am having a problem when i try and copy and paste data. when i copy the injector data from fuel injector clinic then paste to hp tuners the data is not the same. It is off very slightly. Also i am trying to run 2 bar speed density and when i copy the 105kpa table from PE over to the BE table the numbers aren't the same also. Has anyone seen this before? Is this normal. Thanks

[Nutty Cutty]

I experienced the same issue today when copying and pasting injector data. U was pasting . 725 but it would input .729 every single time. I tried it using the equals, directly pasting and changing each field. I even tried to change the number of decimals and make it round up to what I wanted but it still inputs .729 where I'm trying to input .725

[Lakegoat]

That's the way it works. That tiny bit of difference is not going to make any difference in the tune. Let me check my 105 row and see if it is different.
My Primary and Boost 105 row is the same. Here is a pic.